Think of each supply duct as a pipe that is slowly narrowing from the inside. Dust settles on the walls, sticks to the fine fibres of flexible ducting and builds into a soft grey lining. A few millimetres may not sound like much, but across a long run to a back bedroom it adds real resistance. The fan pushes the same effort into the system and less air comes out the far end, which is why the rooms furthest from the unit usually suffer first.
Our clean-out works through every supply run in turn. A rotary brush on a flexible cable is fed into the duct to loosen the lining, while a high-suction extraction unit connected to the system pulls that debris out rather than letting it settle back down. We work from the plenum outwards and back again, paying attention to bends, junctions and the long flexible runs where build-up is usually heaviest. Each outlet is cleaned as its duct is finished, so the home goes back together room by room.
Brisbane systems run hard for much of the year, and southside homes range from Queenslanders with retrofitted ducting under the roof to modern townhouses with compact ceiling voids. The method stays the same, but we plan the order of work around your layout so the job moves along without wasted steps. If we find a run that is too damaged to clean safely, we stop and show you. You will know which ducts were cleaned, which need a closer look and how the airflow compares with when we arrived.